HIGH JUMP PIT SPECS

1) 19 oz. high tear strength vinyl coated polyester.
(2) 10 handles on each section for easy handling reinforced on inside and outside of encasement.
(3) Each section to have two easy release buckles and straps at each corner reinforced with backing on inside and outside of encasement.
(4) Grommets on bottom of each section for drainage.
(5) Two layers of specially selected polyurethane foam. Top layer of foam to be 13 in. thick with continuous foam rails on bottoms and with additional
foam of higher density equally spaced between rails to prevent curling under.
(6) Each section to have heavy duty welded "D" rings around tops and bottoms of all sections to match snaps of landing pad and weather cover.
(7) All seams where mesh is attached to vinyl is double sewn for strength.
(8) All zipper to be heavy duty black nylon. Durable and non corrosive.
(9) All straps for buckles on sections and snap straps on landing pad and weather cover to be made of the same vinyl used on the sections for strength,
durability, and matching color.
LANDING PAD
Three inch thick landing pad with vinyl boxing around entire perimeter for extra strength. Solid brass snaps sewn to bottom side of landing
pad and reinforced with vinyl trim.
(1) Snaps are non corrosive and heavy duty for long lasting use.
(2) Mesh to be heat sealed at seams and double sewn along edges.
WEATHER COVER
(1) 19 oz. vinyl with all seams across pit heat sealed for water proofing.
(2) Skirt to drop down 24 inches with snaps to match section "D" rings

Specifications for Recovering all High Jump Pits and all Conversion Kits.

Sizes to be determined by field measurements.
Material Specifications and workmanship
(1) 19 oz. high tear strength vinyl coated polyester.
(2) 10handles on each section for easy handling reinforced on inside of encasement.
(3) Each section to have two easy release buckles and straps at each corner reinforced with backing on inside of encasement.
(4) Grommets on bottom of each section for drainage.
(5) Existing foam to be field checked and repaired as needed.
(6) Each section to have heavy duty welded "D" rings around bottoms to match snaps of weather cover skirts.
(7) All seams where mesh is attached to vinyl is double sewn for strength.
(8) All zipper to be heavy duty black nylon. Durable and non corrosive.
(9) All straps for buckles on sections and snap straps on landing pad and weather cover to be made of the same vinyl used on the
sections for strength, durability, and matching color.
LANDING PAD
Three inch thick landing pad with concealed snaps on underside of landing pad which attach to matching "D" rings on each section.
(1) Snaps are non corrosive and heavy duty for long lasting use.
(2) Mesh to be heat sealed at seams and double sewn along edges.
WEATHER COVER
(1) 19 oz. vinyl with all seams across pit heat sealed for water proofing.
(2) Skirt to drop down within 4 inches from bottom of each section with snaps to match section "D" rings.